Slate Flashing

Fixing a Tile Flashing

Troubleshooting/FAQ's

Fixing the Tile Flashing

Steps 1-10

1-10 | 11-21

Shaping tiles

Depending on the height of the tiles and proximity to the base of the window, it is sometimes necessary (with profiled tiles) to shape the tiles underneath the window to allow the corrugated apron to sit down correctly.

Click for video

Tile Flashing 1/21

Cutting tiles

Measure out the desired cut point and use an agle grinder to chamfer the edges.

Tile Flashing 2/21

Replace tiles

Replace the bottom course of tiles.

Flat tiles should have a gap of 0-40mm to the frame.

Profiled tiles should have a gap then 60-80mm to the frame.

Tile Flashing 3/21

Install bottom flashing

Fix the bottom flashing section to the frame. Using your hands, press and smooth the apron to the contours of the tiles. If necessary, a rubber mallet may be used carefully to shape the apron.

Click for video

Tile Flashing 4/21

Fit bottom cover

Fit the bottom window cover part.

Tile Flashing 5/21

Secure using screws

Fix using screws provided.

Tile Flashing 6/21

Fit side flashing

Fit the side flashing sections.

Tile Flashing 7/21

Check side flashing alignment

Make sure the side flashing section locates in the bottom section.

Tile Flashing 8/21

Secure side flashing

Pin to the side of the frame.

Tile Flashing 9/21

Fit side covers

Fit side cover parts.

Tile Flashing 10/21

Fixing the Tile Flashing

Steps 1-10

1-10 | 11-21


Terms & Conditions \| Privacy	All content © 2002 Fenstra.net